Emulsion MS

Emulsion MS is used for plant or road mixes with coarse aggregates minimum 80 percent, all of which is retained on 2.36 mm. Our bitumen is processed using sophisticated technology and quality tested chemical compound in conformity with the predefined industry standards. This bitumen can be availed in various colors and can be customized as per information provided by our clients.

Features:

Minimal preparation time for surface repair
Least interference with traffic
Environment friendly
Bonds well to cool, damp surfaces
Ease in application
No heating required
Bond with existing surface
Instant setting and fast development of strength
Low temperature cure
Economical
Stable patches
Resistance to peel off under traffic
Resistance to stripping by water

Other Details:

Premix Carpet: For economical and fast construction of wearing course, emulsion is used for Premix Carpet. Ministry of Road Transport & Highway (MORT&H) has also recommended use of emulsion for this application in their clause 506.2. A tack coat is applied on the cleaned surface. The cold mix is prepared as per the above method and spread over the existing surface followed by either liquid seal coat or a premix seal coat.

Maintenance Mix: This high quality material now makes it possible to fill pot holes or carry out patch repair with open graded cold premix made on-site. The methods typically used for the repair of pot holes using asphalt emulsions are throw-and-roll and full-depth removal and replacement. All of these methods involve placing cold mix in the pot hole with a shovel and compacting with a truck tire, vibratory plate compactor or steel wheeled roller.

Specifications:

Characteristics	-
Residue on 600 micron IS Sieve, percent by mass, Max	0.05
Viscosity by saybolt furol viscometer, seconds 1) At 25℃ 2) At 50℃	- 50-300
Coagulation of emulsion at low temperature1)	Nil
Storage stability after 24 h, percent, Max	1
Particle charge	Positive
Coating ability and water resistance: 1) Coating, dry aggregate 2) Coating, after spraying 3) Coating, wet aggregate 4) Coating, after spraying	Good Fair Fair Fair
Stability to mixing with cement (% coagulation), Max	-
Miscibility with water	No Coagulation
Tests on residue: 1) Residue by evaporation, percent, Min 2) Penetration 25℃/100g/5 sec 3) Ductility 27℃/cm, Min 4) Solubility I tricholoethylne, percent by mass, Min	65 60-150 50 98
Distillation in percent volume of distillate recovered at 360℃ at 1) 190℃ 2) 225℃ 3) 260℃ 4) 316℃ 5) Residue at 360℃, percent, Min	-
Water content, percent by mass, Max	-

1) This requirement shall be applicable only under situations where the ambient temperature is below 15℃.
2) The value of solubility is determined on distillation residue at 360℃